The dimensions of the bathroom in a 3-room apartment are p44. Typical house series P44. Hallway, living room, bedroom, kitchen, bathroom decoration

These dimensions were taken by me personally in my apartment at the stage of finishing the installation of the house. Regarding the size, it is worth noting that the higher the floor, the more area apartments as the walls on the upper floors are darker. In my case, the area of the apartment is 0.5 square meters more than the area specified in the preliminary contract for the sale of the apartment, and this is more pleasant than getting a minus in the area of the apartment located on one of the lower floors.

Now let's go directly to the layout of the apartment and compare it with another offer of a three-room apartment in the house of the 111-M series from the GVSU company. Measurements of a three-room apartment are shown in the following figure:

Comparison of 3-room apartments of the P-44T and 111-M series

The area of these apartments is almost the same - who likes what more. This is a matter of taste and needs, but I liked the layout of the P-44T more. Why?

1. Location of the bathroom.

In P44-T, the bathroom is located in the corridor near the entrance hall, and in 111 between two rooms. In the second option, in the rooms near the bathroom, the sound of water, doors opening and closing will always be heard, which will break the silence in these rooms.

2. Kitchen.

In P44-t and 111-M, the kitchens have similar areas, but in the first version, the kitchen has a bay window. Thanks to the bay window in the kitchen, there will always be light, the kitchen will have a more beautiful view.

3. Corridor.

In the P-44t, the corridor is wider and shorter, which will make it possible to install nice closet for non-seasonal clothes and other things, and in the 111th corridor is narrow and long, which does not allow using its area to good use.

4 rooms

In P-44T, I liked the fact that the rooms are wider, which allows more full use of their area, and in 111-M the rooms are rather narrow, which will not allow furniture to be placed on both sides of the rooms. Also in P-44T all rooms different sizes, thanks to this you will have more "manoeuvres" in choosing the assignments of each of the three rooms.

5. Balconies

The P-44T has two rather spacious balconies, and the 111 has only one. It should be noted that the cost square meter cold rooms, as a rule, are half lower than residential, which means that you pay half as much for balconies and at the same time get more square meters.

6. Fanion boxes

The location of the ventilation ducts in both versions is quite successful, but note to the fact that in P-44t the box is located in the corridor and if the house is higher than 17 floors, then the plus turns into a minus, since a second box appears next to the first and the corridor opposite the bathroom becomes narrow ^

If you have any questions, then ask them in the comments - I will definitely answer them!

Reasons why you need to agree on the redevelopment in the house of the P-44 series

1. If you were given a fine and an order, and you did not comply with the requirements of the regulatory authorities, you can be evicted, and the apartment itself with an uncoordinated redevelopment will be put up for public auction.

2. You urgently need to privatize an apartment, but privatization is impossible with uncoordinated redevelopment.

3. Safety assessment of the planned redevelopment works.

4. You plan to get a loan secured by real estate, but due to the presence of an uncoordinated redevelopment, the bank refuses to issue you Money, since the apartment or premises is considered illiquid.

5. Decrease in the cost of an apartment with an uncoordinated redevelopment when selling is lower by 20% than a similar apartment without redevelopment.

6. When selling real estate on a mortgage, the bank refuses to invest in an object with uncoordinated redevelopment.

Have questions? Call or write, we will help you solve your problem.

5. Enlarge the kitchen or bathroom at the expense of the living room area.

6. Enlarge the living room due to the area of the kitchen or bathroom.

7. Install underfloor heating in the apartment through the use of a common house heating system.

8. Combining the room and kitchen with gas stove without installing a door.

How we will work with you

1. Application of the Customer for the execution of work on the coordination of redevelopment non-residential premises in a residential building in the following form:

Phone call to company consultants;

Filling out an application on the company's website;

Sending an e-mail with the initial data on the object (BTI plans, redevelopment sketch, information about the object).

2. If the Customer fails to provide any relevant information that affects the quality, cost and timing of work to agree on the redevelopment of the facility, the company's specialists contact the Customer and request the missing data.

3. Receipt by the Customer of an individual proposal indicating the scope of work, cost and terms of the service.

4. Conclusion of the Agreement, making an advance payment by the Customer to the account of the Contractor.

5. Departure of the company's specialists to the facility.

6. Performance of work on the development of design and technical documentation.

7. Coordination of design and technical documentation in the authorities of the city with obtaining a Permit to perform repair and construction work.

8. Notifying the Customer about the readiness of the documentation, agreeing on the date and time of its transfer.

9. Meeting with the Customer, transfer of documentation.

10. Familiarization of the Customer with the received documents, signing the closing documents of this stage of the Agreement (Act of Completion of Works), making a payment by the Customer to the account of the Contractor.

11. Performing work on obtaining the Certificate of Completed Reorganization.

12. Receipt of the Act on the completed reorganization in the Moscow Housing Inspection and notification of the Customer about its readiness.

13. Familiarization of the Customer with the documents received, signing the closing documents of this stage of the Agreement (Act of Completion), payment by the Customer to the account of the Contractor.

14. Performance of work on making changes to the technical documentation of the BTI.

15. Receipt of BTI floor plans with redevelopment and notification of the Customer about their readiness.

16. Familiarization of the Customer with the received documents, signing the closing documents of this stage of the Agreement (Act of Completion of Works), making a payment by the Customer to the account of the Contractor.

17. Implementation of work to amend the USRN.

18. Receipt of documents from the USRN with the redevelopment made and notification of the Customer about their readiness.

19. Familiarization of the Customer with the received documents, signing of the closing documents under the Agreement (Act of Completion of Works), making the final payment by the Customer to the account of the Contractor.

One of the most popular series built in Moscow. It got its name due to the panel structure, while the shape of the house usually takes the form of the letter “P” or “L”. Houses of this series have been put into operation since the late 70s. to 2000 It already exists in various modification versions, such as I-1731 (several houses built in the late 90s, which differ decorative panels lower floors and soft facing of the upper ones); P-44T(from 1997 to present, improved exterior finish buildings, has been added attic floor); P-44K(from 2006 to the present, they have a compact form, and therefore only one- and two-room apartments are present in the floor plans); P-44M(from 1997 to 2000, four-room apartments and attics appeared in the layouts, bay windows and additional bathrooms were added), P-44T25(from 2005 to the present, the features of this series are panoramic windows in apartments with winter garden and spacious kitchens up to 16m2); HouseAbove(from 2015 to the present, flat facades, the absence of bay windows and “hidden” behind facade panels loggias); DomRick(from 2015 to the present, updated heat meters have been installed in the heating system, metal-polymer pipes have been used in water supply and heating systems).

residential sections in house series P-44 have two types - angular and ordinary. If the series is ordinary, then there are four apartments on the floor: two two-room apartments with an area of 50.2 sq.m. and 57.8 sq.m., one one-room apartment with a total area of 37.8 sq.m and one three-room apartment with a total area of 73.8 meters. In the corner section there are only two- and three-room apartments. The internal walls are load-bearing in increments of 3.0 and 3.6 m concrete panels 18 cm thick. Wall panels- hinged, reinforced concrete three-layer panels 22 and 28 cm thick, lined with large-sized glazed ceramic tiles. The floor panels are supported by internal walls. For the foundation, a monolithic reinforced concrete slab on a natural basis.

In one-room apartments, the role of the carrier becomes the wall between the kitchen, floor slabs lie on it, and if there is no wall, then the slabs will fall. The maximum that can be done is an opening in the wall between the kitchen and the room wide in general cases. Nevertheless, the layout itself is quite comfortable: the rooms are isolated, the hallways are large, the kitchens are at least 8 sq.m. AT series of residential buildings P-44 the minuses include a small living room in the "three rubles" - only 11 sq.m.; the standard for that time ceiling height of 2.64 meters. Also, many residents complain about the dampness of the latest models and that in some houses, the floors of the balconies are crooked.

The houses provide for such amenities as 2 elevators: with a carrying capacity of 320 and 500 kg with an overhead location of the machine room; as well as garbage chutes with a loading valve on each floor. The number of floors varies from 8 to 17, in connection with which the number of entrances is from 2 or more. As fire-fighting measures to prevent smoke in the evacuation routes in the house, smoke exhaust and air overpressure systems are provided, which are turned on automatically at the signal of apartment heat detectors and from buttons installed in the niches of fire hydrants on each floor. As redundant ways of fire evacuation of residents in the 2-16th floors, transitions are provided along the balconies to adjacent sections, and in the loggias of apartments at the ends of the building - hatches and ladders at the level of the 2nd-16th floors.

Due to the fact that the houses of this series can serve for a very long time, you should not hope for demolition in the near future.

discussion on the forum (reviews, redevelopment):

Domestic construction innovation

The design series P-44 was first implemented in the late 70s. At that time, the house built according to this project was considered original, having no analogues in domestic construction. Indeed, the 10m2 kitchen seemed huge compared to the standard 6m2 with a ponytail. A hall appeared in the apartments, which was not in the "Khrushchev" houses. The smallest hall is in two room apartment(50.2 m2), and is 4.8 m2. In a three-room apartment, the hall is as much as 13 "squares", and in a one-room apartment - 6.5 m2.

At the entrance to the entrance there is a place for a concierge, the house is equipped with a cargo and passenger elevator. Each apartment, except for the first floor, has balconies.

A separate bathroom is provided only in two- and three-room apartments, in a one-room apartment it is combined. The house has a garbage chute with loading valves on each floor.

The P-44 series was built with improved operational features. The builders used panels of a three-layer type with a lock connection. characteristic feature apartments was that there were no walk-through rooms. External walls were erected from hinged three-layer panels. Reinforced concrete slabs and panels are used for floors, interior and exterior partitions.

An interesting feature of the three-room apartment was the possibility of its redevelopment, which was not previously envisaged. The fact is that the wall between the living room and the corridor is allowed to be demolished, the wall is not load-bearing.

The roof of the house has flat roof, the attic is insulated, so the cold from the roof does not blow into the upper apartments. A technical floor is provided above the residential floor.

At the final stage, attention outdoor decoration. Gray, nondescript houses are a thing of the past, the panels for the houses of this series began to be decorated with glazed facade tiles beige, blue and light green. This facade gave the building an elegant and neat appearance.

Among other advantages of the early P-44 houses, internal concrete walls in which there is no expanded clay. Thanks to this, it is easy to drill a hole in the wall for household needs. A smoke exhaust system has been thought out in the floor corridors.

The disadvantages include the mediocrity of fastening panels in some cases, as well as curved floors on the balconies. AT three-room apartment– small living room (11 m2). The designers didn't bother to change standard height ceiling, it still remained 2.64 meters.

Layout of apartments P-44

The multi-apartment house P-44 is divided into sections - they are ordinary and corner. Different layouts of apartments are distinguished from the type of section. There are 4 apartments in the corner type section: two 2-room apartments and two 3-room apartments.

There are also four apartments in the ordinary section. These are two 2-room apartments with different areas: 50.2 m2 - linear and 57.8 m2, popularly referred to as "vest". Two other apartments - 3-room apartment in 73.8m2 and studio apartment at 37.8 m2.

The P-44 house project is a mass series, such houses are found not only in Moscow, but in other cities of Russia and Ukraine. According to this project, residential areas were built in the 90s, in the early 2000s, the manufacturer switched to the production of new modified series P-44T and P-44K .

(See plans below, click to enlarge)

general characteristics

panel residential buildings from ordinary and end four-apartment sections with 1-, 2-, 3-, 4-room apartments.

number of storeys 17 floors

Elevators: 2 elevators - passenger with a carrying capacity of 400 kg and cargo-passenger - 630 kg.

Ventilation: natural exhaust through ventilation units in the bathroom and in the kitchen

Building construction: external walls - three-layer panels 300 mm thick. Internal - reinforced concrete 140 and 180 mm thick. Partitions - 80 mm. Ceilings - reinforced concrete.

Garbage chute: with loading valves on each floor.

Exterior walls:- three-layer panels 300 mm thick.

Internal:- reinforced concrete 140 and 180 mm thick. Partitions-80 mm.

Covers:- reinforced concrete.

The ceiling height of residential premises is 2.64 m. The apartments have convenient layout, spacious kitchens and hallways, large bathrooms. Houses of the P-44 series have been built since 1979. The advantages of their design in comparison with houses of earlier development: the size of the kitchen (8-10 sq. m), the absence of adjacent rooms, comfortable bathrooms, spacious hallways, the presence of a balcony (s) in each apartment, two elevators.